Audix Microphones M3 Tri-Element Hanging Ceiling Microphone with Junction Box and Breakout Cable

Herman # AUDM3W
MFR # M3W
Audix Microphones

$1,195.00

Audix Microphones Audix Microphones

Audix Microphones M3W

Installed Sound, Microphone
Tri-Element Hanging Ceiling Microphone. Includes junction box and breakout cable.
 
The M3 is an innovative, tri-element hanging ceiling microphone designed for applications where aesthetics, sound quality, and ease of installation are critical. The M3 is an ideal audio capture solution for video conferencing, distance learning, courtroom activities, and surgical procedures. It can also be used for ambient room miking and surveillance.
 
The M3 ceiling microphone incorporates three phase coherent hypercardioid capsules with tailored frequency response optimized for speech intelligibility. This is accomplished by minimizing frequencies caused by noise, vibration, paper shuffling, keyboard strokes, fans, and heating /air conditioning. Low noise preamp circuitry is employed for highest possible signal to noise and studio quality sound. A high-quality silicone jacketed microphone cable ensures a balanced, shielded signal and a very clean look. Electronics above the ceiling are housed within a plenum rated junction box and cable connections are made via an RJ45 connector embedded within a proprietary brass housing for an airtight seal.
 
The M3 installed ceiling microphone connects to the input of a mixer or dsp console via a breakout cable (provided). The breakout cable consists of a female RJ45 connector that terminates in either three terminal block or XLR connectors. A variety of optional shielded CAT7 cable lengths (from plenum rated junction box to break out cable) are available.
 
Installing the M3 requires drilling just one 5/8-inch hole in the ceiling, with no additional tools needed. The M3 mounting hardware easily adjusts the cable hanging height up to four feet from the ceiling surface without removing ceiling tiles. A wire safety cable provides additional seismic restraint.
 
Features:
  • 100% RF shielding and immunity 
  • Gold diaphragm condenser capsules with studio quality sound 
  • Low impedance design allows for extremely long cable runs (if required) without cross talk or interference
  • Frequency and pattern tailored for voice clarity and rejection of extraneous noise
  • Evenly dispersed sound with undetectable phase 
  • High-quality silicone jacketed microphone cable with adjustable length and position 
  • Plenum rated junction box with RJ45 connector 
  • All visible components of the microphone and cable are same color: charcoal or white
  • TAA compliant
  • Very high output, low self-noise 
  • Easy to install
Applications
  • Zone Capture
  • Video Conferencing
  • Distance Learning
  • Hospital and medical procedure
  • Courtroom
  • Ambient room miking
What's In The Box
  • 1 x M3 Ceiling Microphone
  • 1 x JBM3 Plenum Rated Junction Box
  • 1 x ANCHRJB60V2 Seismic/fire Strain Relief
  • 1 x CBLM3TERM Breakout Cable
M3 Specs:
Transducer Type: Pre-Polarized Condenser
Frequency Response: 30 Hz – 19 kHz
Optimized Response: 70 Hz – 9 kHz (see chart)
Polar Pattern: Hypercardioid
Output Impedance: 150 Ohms balanced
Sensitivity: 34 mV / Pa @ 1k
Off Axis Rejection: 1 capsule >23 dB at 180º relative to 0º; 2 capsules >18 dB at 120º; 3 capsules >9 dB at 60º
Signal/Noise Ratio (A-weighted): 72 dB
Equivalent Noise Level (Aweighted): 22 dB (A weighted)
Maximum SPL @ .5% THD: ≥128 dB
Dynamic Range: 106 dB
Power Requirements: 18 – 52 Volts phantom
Cable/Connector: Terminal block or XLR
Polarity: Positive pressure on diaphragm produces positive voltage on pin 2 relative to pin 3
Weight: 95 grams (mic only) / 3.32 ounces
Diameter: 50mm (2 inches)
Length: 30mm (1.2 inches)
Part NumberColorPriceQty.

AUDM3W

White$1,195.00

This item has been added to your cart.

AUDM3G

Grey$1,195.00

This item has been added to your cart.

Currently, there are not any Learning Center items related to this specific product. Search for articles on other products.